The working surface of a granite platform should have a uniform color and must be free from cracks, depressions, loose textures, as well as grinding marks, scratches, burns, or other defects that could affect its accuracy. However, minor defects that don't impact accuracy are permissible during use. Importantly, any depressions or chipped corners on the working surface cannot be repaired.
During use, even if a granite tool is struck by a heavy object, it will at most chip off a few small pieces. This superior durability, compared to precision measurement reference parts made from high-quality cast iron or steel, allows granite surface plates to maintain high and stable accuracy over time.
The working surface must be free from significant flaws like sand holes, air bubbles, cracks, inclusions, shrinkage porosity, scratches, bumps, or rust that could compromise appearance or performance. Non-working surfaces, though, can have their depressions or chipped corners repaired.
Granite surface plates should be manufactured from fine-grained, dense materials such as gabbro, diabase, or granite (with biotite content less than 5%, elastic modulus greater than 0.6×10⁻⁴ Kg/cm², and water absorption less than 0.25%). The hardness of the working surface should exceed 70 HS. For 000 and 00 grade plates, it's recommended not to install handling handles. If grade 0 and 1 plates have threaded holes (or grooves) on their surface, these must not protrude above the working surface.
The maximum allowable surface roughness Ra for the working surface is 0.32~0.63μm, while for the side surfaces, it's 10μm. The perpendicularity tolerance of the side surfaces to the working surface and between adjacent side surfaces should comply with grade 12 as specified in GB/T1184. Additionally, there are specific regulations regarding the concentrated load area at the center of the working surface, the applied rated load, and the allowable deflection values.






